Made especially for stucco applications, the reglet is put in place over 3Ú4" baseboard prior to lathing, and the Springlok flashing is locked into place after the roofing paper is applied. Then stucco is applied over the top. This system requires a backing (nailer) with sufficient depth to support the reglet and provide tension to create the proper fit.   Flashing snaps in under the reglet so water can't get under the flashing. A 1" end lap on the reglet and a 3" end lap on the flashing eliminate leaky butt joints to ensure a watertight seal.  End laps on reglet and flashing allow for proper alignment during installation for a waterproof seal.  Flashing has a positive air break to prevent water from climbing under the flashing. Springlok flashing systems have been tested and proven to resist high wind velocities up to 110 mph.  Lightweight material is manufactured in 10' lengths for easy handling and installation on the job site. Precision, factory produced parts ensure a perfect fit on the job. Order factory fabricated reglet and flashing corners and eliminate time-consuming site fabrication. Springlok flashing snaps into reglets without screws or clips, which means you can detach and reuse it when you need to reroof.