STX reglet is specifically engineered for stucco over block conditions, and designed to accept Springlok flashing and other flexible flashing. A "V" projection allows stucco to be applied directly over the reglet. The efficient design of the STX reglet eliminates the need for a backing (nailer).   Flashing snaps in under the reglet so water can't get under the flashing. A 1" end lap on the reglet and a 3" end lap on the flashing eliminate leaky butt joints to ensure a watertight seal.  End laps on reglet and flashing allow for proper alignment during installation for a waterproof seal.  Flashing has a positive air break to prevent water from climbing under the flashing. Springlok flashing systems have been tested and proven to resist high wind velocities up to 110 mph.  Lightweight material is manufactured in 10' lengths for easy handling and installation on the job site. Precision, factory produced parts ensure a perfect fit on the job. Order factory fabricated reglet and flashing corners and eliminate time-consuming site fabrication. Springlok flashing snaps into reglets without screws or clips, which means you can detach and reuse it when you need to reroof.